Onicon F-3100 MOD Uživatelský manuál stáhnout pdf (Strana 11)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-3100-MOD Flow Meter Network Interface Installation Guide 05/14 - 0725-1 Page 11

Flow Meter Operating Status Register (Address 35)

Bit# Description Comment

000 Coil pulse rate too fast for coil diameter Check for programming error for coil diamter

and/or sample rate.

001 Maximum ow alarm is active

002 Minimum ow alarm is active

003 Flow rate exceeds full scale value Change full scale setting

004 Not used

005 Noisy or open elctrode signal Check wiring

006 Empty pipe

007 Coil open or disconnected Check wiring

008 Alternate ow range active

009 Flow rate below low ow cut-off Check low ow cut-off setting

010 Flow in the negative direction

011 Not used

012 Not used

013 Not used

014 Calibration cycle in progress

015 Flow simulation mode active

1 2 ... 6 7 8 9 10 11 12

Žádné komentáře

Onicon F-3100 MOD Uživatelský manuál Strana 11