Onicon F-3100 Series Uživatelský manuál stáhnout pdf (Strana 39)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-3100 Flow Meter Manual 06/14 - 0670-7 Page 2

Step 1

Remove the cover and

circuit board from the

remote mount junction

box.

Section 2: Installing the Remote Mount Junction Box

Step 2

Feed the cales through

the holes in the bottom

of the junction box

and mount it in place.

Step 3

Re-install the cir-

cuit board.

Step 4

Attach the cables to

the terminal blocks

as shown.

Step 5

Install the remote

mount cable through

the strain relief

supplied with the

junction box.

Step 8

Re-install the

cover.

(Note: Each wire is labeled with

a number that corresponds to a

terminal location.)

Step 7

Cables should

be connected

as shown.

Remote

transmitter

cable

Sensor

cables

Step 6

Install the remote

mount cable to the

numbered terminal

block positions.

1 2 ... 34 35 36 37 38 39 40 41

F-3100 SERIES 1
SAFETY INFORMATION 3
SECTION 1.0: INTRODUCTION 7
FLOW METER 11
CERTIFICATE OF CALIBRATION 11
SECTION 3.0: INSTALLATION 12
FLOW DIRECTION 13
IMPORTANT NOTE 14
Shown with 4-bolt pattern 16
Sensor Size 17
The eyebolts are 18
Flow direction 20
Flow Direction 21
Liner material 23
3.2.7 Torque Specications 25
0.25” DIA 26
CAUTION/WARNING 27
Step 5: 29
Cable wires are 31
= = = = = = = > 33
< = = = = = = = 33
DESCRIPTION 36
APPENDIX 37
A-4 CONDITIONS OF SALE 37
Wiring Instructions 38
CONDITIONS OF SALE 41

Komentáře k této Příručce

Žádné komentáře

Onicon F-3100 Series Uživatelský manuál Strana 39

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Onicon F-3100 Series