Onicon System-30 BTU Uživatelský manuál stáhnout pdf (Strana 30)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-30 BTU Measurement System Manual 05/14 - 0667-2 / 18335 Page A-8

Dual Mode BTU Meters

DUAL MODE BTU METERS – RUN MODE DISPLAY PAGES

PAGE No. DISPLAY NAME SELECTABLE UNITS

MODE 1 ENERGY TOTAL BTU, TONHR or KWHR

MODE 1 FLOW TOTAL GAL, LITER, METERS

MODE 2 ENERGY TOTAL BTU, TONHR or KWHR

MODE 2 FLOW TOTAL GAL, LITER, METERS

ENERGY RATE BTU/HR, TONS or KW

FLOW RATE GPM, GPH, MGD, L/SEC, L/MIN, L/HR, METERS

/HR

INTRN TEMPERATURE DEG F, DEG C

EXTRN TEMPERATURE DEG F, DEG C

Di3 PULSE TOTAL

COUNTS or TEXT ENTRY

ALARM STATUS NOT APPLICABLE

SERIAL NUMBER NOT APPLICABLE

1.3 UNITS AND MULTIPLIERS

The units and multipliers are programmed prior to delivery. Contact ONICON for assistance in

changing units or multipliers.

1.4 ENABLING / DISABLING FRONT PANEL RESET

The table below explains how to enable or disable the front panel reset.

STEP ACTION REACTION COMMENT

With the Btu meter running,

carefully open the cover and

locate ADD/PROG EN. Press

ADD/PROG EN and then

release it.

None. DEV ADD/PROG ENAB is

located on the right edge of

the Btu computer board. (see

appendix page A-9.)

Replace the cover.

Press the PROGRAM button.

(If you do not press the

PROGRAM button, the meter

will revert to the run mode

after 5 minutes.)

The Btu meter changes

to program mode and the

DEVICE ID page will

appear with the rst digit

of the address ashing.

The PROGRAM button is on

the front panel.

DO NOT CHANGE THE

DEVICE ADDRESS.

Press the PROGRAM button. The FRONT PANEL RESET

page appears with the N or

Y ashing.

The PROGRAM button is on

the front panel.

Press the SCROLL button. The setting will toggle

between N and Y.

Enable or disable the FRONT

PANEL RESET as necessary.

Press the PROGRAM button. The SAVE CHANGES page

appears with the N

ashing.

The new FRONT PANEL

RESET setting must be saved

to take effect.

Press the SCROLL button. The N changes to Y. The Y must be selected for the

new address to take effect.

Press the PROGRAM button. The new setting is saved

and the display reverts to

the run mode.

The PROGRAM button is on

the front panel.

1 2 ... 25 26 27 28 29 30 31

Komentáře k této Příručce

Žádné komentáře

Onicon System-30 BTU Uživatelský manuál Strana 30

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Onicon System-30 BTU