Onicon System-30 MODBUS BTU Uživatelský manuál Strana 16

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 15
11451 South Belcher Road, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
System-30 BTU Measurement System MODBUS RTU RS485 04/14 - 0583-1 / 18345 Page 16
3.3.2 Electrical Wiring
Connect all Btu meter signal outputs to terminal strip TB1 and/or TB4 (optional
communication output) as shown below. Then connect the 24 V AC/DC input power to
terminal strip TB1. The standard SYSTEM-30 is congured for 24 V AC 50/60 Hz
operation or 24 V DC operation. Do not connect the 24 V AC/DC source until all other
signal connections have been made and veried.
CAUTION
Only qualied service personnel should make connections between the System-30-MOD BTU
Meter and the user’s external equipment. ONICON assumes no responsibility for damaged caused
tot he external equipment as a result of an improper installation.
!
1
2
3
4
5
1
2
3
4
5
6
7
8
TB1
TB4
+
-
Btu Mode 1Contact
Btu Mode 2 Contact
}
}
}
24V AC/DC
+
-
}
Analog Output
+
-
}
RS485
+
-
}
Aux Pulse Input
RS485 Common
Zobrazit stránku 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

Komentáře k této Příručce

Žádné komentáře