Onicon D-100 BACnet Uživatelský manuál stáhnout pdf (Strana 11)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-100 Display Module BACnet Installation and Operation Guide 05/14 - 0635-6 / 18341 Page 11

1.5 BACnet MS/TP BAUD RATE, BIASING & TERMINATION

1.5.1 Baud Rate

Every ONICON D-100 is individually programmed at the factory with application specic

data provided by the customer during the process of ordering the display, and this

normally includes the Baud rate setting. If the Baud rate was provided, the display will be

congured to operate at the specied rate. The standard Baud rate settings are 9600,

19200, 38400 and 76800 Baud.

If the Baud rate setting was not provided to ONICON, the D-100 will be congured to

“auto” detect the Baud rate of the network. In this conguration, the display should detect

and automatically adjust to the proper rate when it is connected to the network.

The Baud rate setting can be manually changed in the eld. The photos and table below

show the Baud rate dipswitch settings.

B1 B2 B3 B4 Rate

0 0 0 0 Autobaud

1 0 0 0 9600

0 1 0 0 19200

0 0 1 0 38400

0 0 0 1 76800

Baud Rate Dip Switches

(Circuit board shown upside down for clarity.)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Žádné komentáře

Onicon D-100 BACnet Uživatelský manuál Strana 11