Onicon D-100 BACnet Uživatelský manuál stáhnout pdf (Strana 14)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-100 Display Module BACnet Installation and Operation Guide 05/14 - 0635-6 / 18341 Page 14

1.6.2 Changing the IP Address

Changing the IP address requires the use of RUInet utility software and a PC with an

Ethernet card and an available port. Assuming the display is programmed with the default

address (192.168.1.24) the host PC must be congured to operate with an IP address of

192.168.1.1 and a subnet mask of 255.255.255.0. RUInet is supplied on a CD-ROM with

the D-100. It is also available for download from the ONICON website, www.onicon.com.

1. Load RUInet and congure the PC as necessary.

2. Connect an RJ45 Ethernet cable between the PC and the display and power the

D-100. Allow 60 seconds for the display rmware to cycle through start-up

diagnostic routines.

3. Open RUInet.

4. From the Remote User Interface main menu (shown on the next page) select

option “I”, Change IP Address.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Žádné komentáře

Onicon D-100 BACnet Uživatelský manuál Strana 14